Touch Switch
This circuit uses a 555 timer as the bases of the touch switch. When the plate is touched the 555 timer is triggered and the output on pin 3 goes high turning on the LED and the buzzer for a certain period of time. The time that the LED and the buzzer is on is based on the values of the capacitor and resistor connected to pin 6 & 7. The 10M resistor on pin 2 causes the the circuit to be very sensitive to the touch.
Circuit Diagram
July 26, 2009
Touch Switch
Electronics is the study and use of electrical that operate by controlling the flow of electrons or other electrically charged particles in devices such as thermionic valves. and semiconductors. The pure study of such devices is considered as a branch of physics, while the design and construction electronic circuits to solve practical problems is called electronic engineering.
Popular article
-
TFT The TFTs in active-matrix LCD act as simple ON/OFF switches, at different speeds which depend on the refresh rate of the LC...
-
Description: This page describes how to use or connect and use 2 and 3 terminal electret condenser microphones ( ECM's ). The bottom sec...
-
In real this is how an Thermistors looks like.. Thermistors are thermally sensitive resistors and have, according to type, a negative (NTC)...
-
INTRODUCTION:- A silicon-controlled rectifier (or semiconductor-controlled rectifier ) is a four-layer solid state device that controls c...
0 comments:
Post a Comment