July 25, 2009

Geomagnetic field detector

11:56 PM  Sabarish  No comments

Geomagnetic Field Detector

This basic oscillator will detect the Earth magnetic field. The ferrite rod and coil are taken from an old Medium Wave receiver and a small magnet is glued at one end. Tune to a medium wave commercial station until you hear a beat note. Any movement of the ferrite rod will produce an audible note that depends on the prevailing Earth magnetic field. Screening is essential. Use a plastic box padded, on the inside, with copper wires running parallel to the rod and grounded in one place only. A small hole is made in the box in order to adjust the trimmer capacitor with a plastic screwdriver. An American equivalent to the BC337 could be the 2N2369A but I did not try it out.

Circuit Diagram

Posted in:

0 comments:

Post a Comment

DOOR BELL FOR DEAF CLICK HERE

Electronics is the study and use of electrical that operate by controlling the flow of electrons or other electrically charged particles in devices such as thermionic valves. and semiconductors. The pure study of such devices is considered as a branch of physics, while the design and construction electronic circuits to solve practical problems is called electronic engineering.

Popular article

  • Nodal Analysis
    Introduction Kirchoff discovered this: the total current entering a node equals the total current leaving a node ! And, these cur...
  • Teach Yourself Electronics and Electrical
    Teach Yourself Electronics and Electrical This is an e-book written by Stan Gibilisco Download Link : http://rapidshare.com/files/254250245...
  • Tester
    INTRODUCTION this is responsible for testing components as well as checking circuit board tracks, wires and connections for continuity (con...
  • Remote Control IR Transmitter
    Program IR Transmitter This project is based on integrated circuit from Holtek HT6221/HT6222. Similar parts used to be produced by NEC Se...