June 30, 2009

Automatic Emergency Light

AUTOMATIC LOW-POWER EMERGENCY LIGHT
Here is a white-LED-based emergency light
Advantages

1. It is highly bright due to the use of white LED s.
2. The light turns on automatically when mains supply fails, and turns off when mains power resumes.
3. It has its own battery charger.When the battery is fully charged, charging stops automatically.

The circuit comprises two sections charger power supply and LED driver.

The charger power supply section
It is built around 3-terminal adjustable regulator IC LM317 (IC1), while the LED driver section is built around transistor BD140 (T2). In the charger power supply section, input AC mains is stepped down by transformer X1 to deliver 9V, 500 mA to the bridge rectifier, which comprises diodes D1 through D4. Filter capacitor C1 eliminates ripples. Unregulated DC voltage is fed to input pin 3 of IC1 and provides charging current through diode D5 and limiting resistor R16. By adjusting preset VR1, the output voltage can be adjusted to deliver the required charging
current. When the battery gets charged to 6.8V, zener diode ZD1 conducts and charging current from regulator IC1 finds a path through transistor T1 to ground and it stops charging of the battery.

LED Driver section
The LED driver section uses a total of twelve 10mm white LEDs. All the LEDs are connected in parallel with a 100-ohm resistor in series with each. The common-anode junction of all the twelve LEDs is connected to the collector of pnp transistor T2 and the emitter of transistor T2 is directly connected to the positive terminal of 6V battery. The unregulated DC voltage, produced at the cathode junction of diodes D1 and D3, is fed to the base of transistor T2 through a 1-
kilo-ohm resistor. When mains power is available, the base of transistor T2 remains high and
T2 does not conduct. Thus LEDs are off. On the other hand, when mains fails, the base of transistor T2 becomes low and it conducts. This makes all the LEDs (LED1 through LED12) glow.The mains power supply, when available , charges the battery and keeps the LEDs off as
transistor T2 remains cut-off. During mains failure, the charging section stops working and
the battery supply makes the LEDs glow. You can use more LEDs provided the total current consumption does not exceed 1.5A. Driver transistor T2 can deliver up to 1.5A with proper heat-sink arrangement.

Circuit Diagram


NOTE : Click the image for better Quality

Pin Configuration

2 comments:

Nice article to get automatic Emergency Light.Thanks for sharing this article.

It is essential that the emergency lighting is installed, routinely inspected, regularly serviced and maintained by qualified electrical personnel.

Emergency Lights

Post a Comment

DOOR BELL FOR DEAF CLICK HERE

Electronics is the study and use of electrical that operate by controlling the flow of electrons or other electrically charged particles in devices such as thermionic valves. and semiconductors. The pure study of such devices is considered as a branch of physics, while the design and construction electronic circuits to solve practical problems is called electronic engineering.

Popular article